Plywood Dryer Machine-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Industrial knife grinding machine can automatically adjust the grinding parameters according to the material and shape of different knives, and accurately complete the grinding, repair and maintenance of knives.Industrial knife grinding machine are suitable for grinding all kinds of knives, including but not limited to cutting knives, trimming knives, scrapers, milling cutters, turning tools, etc. Whether it is precision cutting, complex-shaped knives, or large-scale tool repairs, knife sharpeners can complete them accurately and quickly.

Veneer dryer is one of the main equipment in the production process of veneer and plywood, and the drying quality of veneer directly affects the quality of veneer and plywood products. The principle is that the veneer is preheated and dried under the clamping of the upper and lower two coils, and the coil is heated by steam or heat conduction oil to transfer the temperature to the veneer.

Recently, the veneer dryer provided by our company was successfully installed in Cambodia and has been put into use. Our engineers go to the customer's factory to guide the installation and will not return until the equipment is running normally and the workers are skilled in operation.The high reliability and low failure rate of veneer drying equipment greatly reduces equipment maintenance and downtime, and improves the overall operating efficiency of the production line.

There are two traditional heat sources for the veneer dryer, namely, steam boiler and thermal oil heater. The advantages using these two heat sources are one machine can provide heat for more than one veneer dryer. Typically, in a large plywood plant, one big capacity steam boiler or thermal oil heater can supply sufficient heat to several veneer dryers, hot press machines, etc. Only one heat source or heat energy center is enough. The disadvantage is the operation cost will be very high like the fuel cost.

Recently, our company's 2 deck veneer dryer in Cambodia was successfully installed and put into operation. With the growing demand for veneer processing, Thailand customers need a set of efficient and stable drying equipment to expand production. After several rounds of technical exchanges and program evaluations with our company, the customer finally chose our 2 deck veneer dryer.

The four deck veneer dryer purchased by myanmar factory is used to dry rubber wood. The customer gives good feedback. It is used with the biomass burner.The biomass burner which as the heat source can provide high temperature to the dryer to make sure the sufficient heat impinged on the wet veneer in an efficient manner. At the same time, the tree bark from debarker and waste veneer from peeling lathe were burned as the fuel directly, which solved the waste accumulation in the veneer plywood making factory.

Recently, the 4 deck fully automatic conveyor dryer machine purchased by our Romanian customer has been tested. It is equipped with a fully automatic veneer feeding and receiving system. Our engineers went to the customer's factory to guide and train the workers. The customer is very satisfied. If you want to see the equipment on site, please contact us.

The 2 deck veneer dryer purchased by our Vietnamese customers has been installed, successfully tested and running normally. During this period, our engineers will train the workers until they are proficient in operation. We welcome you to visit the case site. The veneer dryer is equipped with a biomass burner, which directly burns the bark, saving fuel costs. It uses a new axial flow fan, which reduces power consumption and greatly reduces the power of the whole machine, which can further reduce the user's later operating costs.

The 4deck roller veneer dryer was ready for the shipping. And it needs 10 super heavy containers to stuff all the parts and accessories required for the veneer roller dryer machine. The roller dryer machine will sail to Africa and has the function of drying wet veneer to a proper moisture content.